3842558003

Connection kit active belt bridge VFplus 90 R

Connection kit active belt bridge VFplus 90 R The active belt bridge is used as a transfer unit for bridging the conveyor trench<br>- between the basic unit and return unit<br>- between the start or end of a conveyor section and a third-party conveyor<br>- in the connection drive Only for flat, flocked static friction chain The active belt bridge is driven by a transmission (on the drive or return unit side) Suitable for conveyor belts from approx. 80 mm in length (depending on the speed, position of the center of gravity, product friction, etc.) Installation possible on both the drive and return side (make sure to use the correct L/R version) Not permitted for wet operation, rough ambient conditions or sharp-edged products Load depending on the speed The speed of the adjacent conveyor should be approximately the same to prevent premature wear Simple transmission of the drive force using hexagonal hollow shafts integrated into the base unit or return unit as standard Can be retrofitted into a standard configuration at any time Easy replacement of the belt from the top Accumulation not permitted

Brand	Bosch Rexroth
Lifecycle status	active